Products List
CARBIDE END MILLS (VG Series)
Two Edge Flat Base End Mill Standard Type
Two Edge Flat Base End Mill Lengthen
Two edge flat head milling cutters by the trench milling primarlly, is suitable in HRC≤50 the carbon
steel, the molding tool steel, the alloy steel, the tool steel, the stainless steel, the titanlum alloy and
so on processing
Four Edge Flat Base End Mill Standard Type
Four Edge Flat Base End Mill Standard Lengthen
Four edge end mills by the side fine mill primarily, is suitable in HRC≤50 the carbon steel,the molding tool steel, the alloy steel, the tool steel, the stainlesssteel, the titanium alloyand so on processing
Two edge long neck flat base end mill
The long neck flat base end mill mainly uses in milling of the narrow gulley, is
suitable in HRC≤50 carbon steel, molding tool steel, alloy steel, tool steel,
stainless steel, titanium alloy and so on processing.
Two edge micro trail flat base end mill
Two edge micro trail end mill and the small handle diameter flat base end mill
in the electronic part processing, may coordinate the small knifing, the roughing
feed commonly used to carry on the trench milling, is suitable in HRC≤50 carbon
steel, molding tool steel, alloy steel, tool steel, stainless steel, titanium alloy and
so on processing.
Two edge ball end mill standard type
Two edge long handle ball end mill lengthen
Two edge ball milling cutter may use in the higher cutting or the surface cutting, is
suitable in HRC≤50 carbon steel, molding tool steel, alloy steel, tool steel,
stainless steel, titanium alloy and so on processing.
Two edge micro trail ball end mill (A07)
Two edge micro trail ball end mill and a small handle diameter ball end mill
in the electronic part processing, may coordinate the small knifing, the
roughing feed commonly used to carry on the trench milling, is suitable in
HRC≤'50 carbon steel, molding tool steel, alloy steel, tool steel, stainless
steel, titanium alloy and so on processing.
Two edge straight handle long neck short edge ball end mill (A08)
A long neck short edge ball end mill mainly uses in the narrow gulley the
surface milling, is suitable in HRC≤50 carbon steel, molding tool steel,
alloy steel, tool steel, stainless steel, titanium alloy and so on processing.
Four edge round nose end mill standard type (A09)
Four edge round nose end mill lengthen (A10)
Four edge round nose milling cutter R angle structural design may protect
the knife point not to be easy to crack, may substitute a trail ball milling
cutter to make the clear angle or the surface contour cutting, is suitable
in HRC≤50 carbon steel, molding tool steel, alloy steel, tool steel,
stainless steel, titanium alloy and so on processing.
Three edge aluminum use the flat base end mill (A11-1)
.png)
Three edge aluminum use the flat base end mill (A11-2)
.png)
Three edge aluminum alloy special-purpose flat head milling cutter, has the
good vibration-proof structure, is suitable in thin wall components and so on
aerospace, mold, automobile high speed and the highly effective processing.
Two edge aluminum use a ball end mill (A12-1)
.png)
Two edge long handle ball end mill lengthen (A12-2)
.png)
Two edge ball milling cutter may use in the higher cutting or the surface cutting, is
suitable in HRC≤50 carbon steel, molding tool steel, alloy steel, tool steel,
stainless steel, titanium alloy and so on processing.